diff options
Diffstat (limited to 'drivers/net')
| -rw-r--r-- | drivers/net/can/usb/kvaser_usb.c | 28 | ||||
| -rw-r--r-- | drivers/net/ethernet/ti/cpsw.c | 22 |
2 files changed, 37 insertions, 13 deletions
diff --git a/drivers/net/can/usb/kvaser_usb.c b/drivers/net/can/usb/kvaser_usb.c index 63fb90b00..a3fb8b510 100644 --- a/drivers/net/can/usb/kvaser_usb.c +++ b/drivers/net/can/usb/kvaser_usb.c @@ -579,7 +579,7 @@ static int kvaser_usb_simple_msg_async(struct kvaser_usb_net_priv *priv, usb_sndbulkpipe(dev->udev, dev->bulk_out->bEndpointAddress), buf, msg->len, - kvaser_usb_simple_msg_callback, priv); + kvaser_usb_simple_msg_callback, netdev); usb_anchor_urb(urb, &priv->tx_submitted); err = usb_submit_urb(urb, GFP_ATOMIC); @@ -654,11 +654,6 @@ static void kvaser_usb_rx_error(const struct kvaser_usb *dev, priv = dev->nets[channel]; stats = &priv->netdev->stats; - if (status & M16C_STATE_BUS_RESET) { - kvaser_usb_unlink_tx_urbs(priv); - return; - } - skb = alloc_can_err_skb(priv->netdev, &cf); if (!skb) { stats->rx_dropped++; @@ -669,7 +664,7 @@ static void kvaser_usb_rx_error(const struct kvaser_usb *dev, netdev_dbg(priv->netdev, "Error status: 0x%02x\n", status); - if (status & M16C_STATE_BUS_OFF) { + if (status & (M16C_STATE_BUS_OFF | M16C_STATE_BUS_RESET)) { cf->can_id |= CAN_ERR_BUSOFF; priv->can.can_stats.bus_off++; @@ -695,9 +690,7 @@ static void kvaser_usb_rx_error(const struct kvaser_usb *dev, } new_state = CAN_STATE_ERROR_PASSIVE; - } - - if (status == M16C_STATE_BUS_ERROR) { + } else if (status & M16C_STATE_BUS_ERROR) { if ((priv->can.state < CAN_STATE_ERROR_WARNING) && ((txerr >= 96) || (rxerr >= 96))) { cf->can_id |= CAN_ERR_CRTL; @@ -707,7 +700,8 @@ static void kvaser_usb_rx_error(const struct kvaser_usb *dev, priv->can.can_stats.error_warning++; new_state = CAN_STATE_ERROR_WARNING; - } else if (priv->can.state > CAN_STATE_ERROR_ACTIVE) { + } else if ((priv->can.state > CAN_STATE_ERROR_ACTIVE) && + ((txerr < 96) && (rxerr < 96))) { cf->can_id |= CAN_ERR_PROT; cf->data[2] = CAN_ERR_PROT_ACTIVE; @@ -1583,7 +1577,7 @@ static int kvaser_usb_probe(struct usb_interface *intf, { struct kvaser_usb *dev; int err = -ENOMEM; - int i; + int i, retry = 3; dev = devm_kzalloc(&intf->dev, sizeof(*dev), GFP_KERNEL); if (!dev) @@ -1601,7 +1595,15 @@ static int kvaser_usb_probe(struct usb_interface *intf, usb_set_intfdata(intf, dev); - err = kvaser_usb_get_software_info(dev); + /* On some x86 laptops, plugging a Kvaser device again after + * an unplug makes the firmware always ignore the very first + * command. For such a case, provide some room for retries + * instead of completely exiting the driver. + */ + do { + err = kvaser_usb_get_software_info(dev); + } while (--retry && err == -ETIMEDOUT); + if (err) { dev_err(&intf->dev, "Cannot get software infos, error %d\n", err); diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c index b1ab3a495..e18240de1 100644 --- a/drivers/net/ethernet/ti/cpsw.c +++ b/drivers/net/ethernet/ti/cpsw.c @@ -1293,6 +1293,19 @@ static int cpsw_ndo_vlan_rx_add_vid(struct net_device *ndev, if (vid == priv->data.default_vlan) return 0; + if (priv->data.dual_emac) { + /* In dual EMAC, reserved VLAN id should not be used for + * creating VLAN interfaces as this can break the dual + * EMAC port separation + */ + int i; + + for (i = 0; i < priv->data.slaves; i++) { + if (vid == priv->slaves[i].port_vlan) + return -EINVAL; + } + } + dev_info(priv->dev, "Adding vlanid %d to vlan filter\n", vid); return cpsw_add_vlan_ale_entry(priv, vid); } @@ -1306,6 +1319,15 @@ static int cpsw_ndo_vlan_rx_kill_vid(struct net_device *ndev, if (vid == priv->data.default_vlan) return 0; + if (priv->data.dual_emac) { + int i; + + for (i = 0; i < priv->data.slaves; i++) { + if (vid == priv->slaves[i].port_vlan) + return -EINVAL; + } + } + dev_info(priv->dev, "removing vlanid %d from vlan filter\n", vid); ret = cpsw_ale_del_vlan(priv->ale, vid, 0); if (ret != 0) |